Card Holder
Materials:
1. 1 plastic CD case (the rounded style, not the jewel case style designed for a printed
insert/sleeve)
2. 1 brad
3. Clear packaging tape
4. Screwdriver
5. Scissors
Steps:
1. Open the CD case and bend it backwards and forwards several times.
2. Use your scissors to cut the plastic spine that holds the
two sides together.
3. Use the screwdriver to poke a small hole in the center of
each side of the case.
4. Hold the two sides
together with the
molded parts on the
outside. Push the
brad through the middle and spread the prongs apart. You may have to
bend them a little so they’ll lay down between the molded raised plastic
pieces.
5. Put clear packaging tape over the brad on both sides of the card holder. Put
a strip of tape folded around the bottom of the case to keep the two sides
from swiveling around.
Back to Homemade AT page
